Today was a lot of work, as far as the carbines go. Installed two grips, a trigger guard, 2 Geissele triggers, and a Centurion Rail.
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
Do you know if this specific rail works or even makes sense with a low profile gas block? I do not have a front sight and I don't know that I want the 7" version because I am not sure it will look good with the low profile gas block. OR do you know if the 12" version will fit over top of the low profile gas block. Thanks!… oh and also, do you HAVE to cut the delta ring off, or since i have a low profile block, can I just slip it off?
you'll love it.
Badass I just purchased the centurion arms carbine cutout for my colt 6920
I just ordered that C4 cutout rail so I can just about finish one of the 2 that I have been slowly getting parts for the past 6 months. I hope it works since it is going over a Adams Arms railed gas block piston kit think I am gonna order a cutout Evo for the other both have the AA kit. I put a Battle Arms ambi safety on the one lower when I built it a few weeks ago think I am gonna order a few more for every one of my lowers really nice not to expensive upgrade $50 at Botach for the 2 lever kit
You might want to put the gunfighter insert with the larger tongue in. The shorter piece will really rub your middle finger uncomfortably where the grip meets the trigger guard when using the rifle.
I did consider that. I do not know if it would work. Larue did produce some of the LT100 mounts with the levers on the right side as a special order for some overseas unit of some kind. These work for now. I don't mind riding the CH with my nose on this gun. Call Larue or email to ask. If you find out please let me know.
Great looking ARs there. Have you tried, or do you know if it would work, to switch your LT100 around so the locking levers are on the right side of your AR? I have a LT100 as well and have thought about doing this so it doesn't hit my KAC BUIS and even more so, it makes the left side of the AR "slick" when slung and less likely to snag. Again, great looking video and ARs!
T1 is an awesome choice! The reason behind the ACOG on that gun was, it is my mid range, fun precision gun. Kind of a more traditional M4 platform.
Is the acog a good pair for an ar15? i would think a 556 is mostly an up close fighting tool and a 4x would be to much. i was thinking about an acog but then for that reason i went with an aimpoint t1
Centurion Rail can be had from many sources. Try bravocompanyusa or Rainierarms
I am thinking of trying the new magpul k enhanced grip when it's in stock.
Good deal brother! Looking great.
Thanks for the comment and question Scutler. Look up IWC – Impact Weapon Components. You can buy the MOE with the QD installed or buy the part and install yourself. Great company with many good ideas.
Nice rigs. I too have a 14.5 inch BCM lik yours with a Magpul handguard. Question for you. How did you install the QD in the Magpul handguard?
That was the 6920 I bought in order to get a hold of a lower for another project. Thanks. It was tough cutting this babe apart.
I know you seem to have been torn about taking a dremel to that 6920 but it came out looking totally awesome. I thought you were going to sell the 6920 upper, or was that on ANOTHER 6920 you bought?
nice looking rifles!!!