MAGPUL ASAP sling mount install

Good job

Thank you sir! Great video, got my aasap on perfectly

Thanks

If it lays in there, why did you screw the castle ring that far down?

After 8 years of this video, let me tell you that it helped me a lot.

Thank you. Always good to see different parts for the AR platform.

Mine didn't come with the 2 little crack rocks! What do I do??

Excellent Philly accent

All the fuck I wanna know is how to mount a sling

Thank you and Go Flyers!

I think your video was very informative. Good job.

Filming was fine. Why the hell did magpul design the key separate like that? What a PITA.

Good luck finding the Tango Down clamp. Sold out everywhere

Great vid.

Video was just fine my friend. Helped a ton. Thank you. Since I already bought the Magpul ASAP-QD I’m gonna install. Gonna look into the option you have. not having to break anything down is a much better option. Cheers from the PNW!!!

BAC LOCAL 2 Detroit

Thank you! This video helped out quite a bit! 😁🤙

I cuss alot in my videos. That's how you know you're hard

I just picked up a QD sling plate to replace my ASAP. Good video, love the details and time you took to explain how to do this.

Noice

Where is the torque wrench??

The Castle nut supposed to be torqued down to 40ft/lb

Thanks so much for the video! I didn't get the Magpul ASAP, but instead got the standard dual-loop sling attachment plate, and this video helped me get it on perfectly! That's not to say it was without issue, that damn buffer-tube pin/spring combo as well as the smaller spring/pin that came out that small hole in the back (which I found out is what keeps the rear takedown pin from falling out when you push it out to detach the upper) were a couple of pains in my ass, but once I figured out the correct order to put everything back together, it all went into place smooth as butter. I didn't even need a vice or anything, just did it all free handed. The only tool I used was the castle-nut wrench and the pummel of an old screwdriver to initially work the main 2 takedown & pivot pins loose.

Thanks again for the video and helping this dummy successfully get his dual-loop sling attachment plate on his ar-15 with no great issues!

Love that Tango Down mount. I watched the video to see the Magpul ASAP mount but that Tango Down Mount looks like the better option for me as I never have my stock fully collapsed as well.

“Don’t lose it”

Yeah no shit, just spent an hour and a half tearing apart my garage to find the fucker.

Springco blue buffer Spring and H buffer is the shit Rated for over 150000 Cycles

Ya would like to buy a Fucken. Castle nut and tub. And the adapter for a Russian. Saiga 223. For the stock is that possible rather than listen. To. These hicks. That think everybody is. Stupid. Pickel. Smokers

Thanks for the video man. Life saver

I’ve never seen a crack rock before either 😁 I mangled three of those springs in one Day was just having a bad day and couldn’t pay attention. Had to walk away from it. It was a cerokoted lower….everything was fighting me like Kung fu! Grrrr! Cerokote is very nice but makes for a miserable lower build. Thought I would share that. It’s my new 300 Blk out.