Home AR-15 AR15 Pistol- DPMS 7 inch Barrel

AR15 Pistol- DPMS 7 inch Barrel

2179
47

My AR15 pistol is completely assembled.Lets take a look at what parts I used to build it.

Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.

47 COMMENTS

  1. Are there any downsides to having a pistol AR besides loudness? I know it's cringey but I want to recreate an airsoft gun I have into an actual ar15. It's an m4 with a 4.4 inch rai

  2. I have zero problems on my AR pistol. I put a Adams arms 7&a half inch upper receiver on it. piston Drive Upper is the way to go. the gas tube is too short on the regular AR's. so it throws off the timing on the gun .

  3. Pretty sweet setup. I have a polymer lower and a parts kit I just bought. I want to make it into a pistol first, then I can swap uppers later per ATF rules.. I was thinking perhaps a 300 Blackout pistol upper. Did you install your own barrel, or was that a complete upper already made? Thanks.

Leave a Reply