Watch PART ONE (boresighting) Here:
Turret Adjustment will vary between scope manufacturers, but the process is usually similar, once you’re hitting where you want to, loosen turret screws, once turret is loose, adjust back to zero, and then tighten back down.
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
After first shot, set your crosshairs on bullet hole on target and keep stationary, then move elevation and windage until crosshairs are in center of target. 2 shot sight in procedure never fails and you're not fiddling back and forth with your turrets. Youre welcome.
What is that on top of your stock bro?
Just learned 10 clicks is 1 mil. Thanks bro u explain a lot more than other videos I’ve seen appreciate that 🫡
Bro I've watched hundreds of videos, and your the FIRST to show or explain the zero stop along with your revolutions of the mils!!! Thank you! SUBSCRIBED
Stupid Question but how do you zero windage dial? Unscrew that cap and then what?
Hello friend, what distance did you zero at?