Front and Rear Takedown Pins #556

Wow thanks I just ordered the tool to do the front one didn't see this video lol

sick of everyone using aero lowers and leaving out details with no threads

This may be a stupid question but here goes: I am a 65+ old shooter, I built an AR and do not like the way it shoulders. Do these ar's have to have the buffer tube? Or perhaps a smaller tube?

Are there any ambi lowers less that $200?

Nice. A how-to video that is right to the point, doesn't have annoying music playing, or a split-screen of some yoyo playing video games.

Do you think these make a real difference from basic pivots?

Where was this video 30 minutes ago? 😅

Finally ! Someone with a well explained how to video 💯

Hey I literally have the same lower do you know about how long the front take down pin spring has to be ?

Easily the most frustrating part of building an AR platform gun 😂 they make a cool special tool for it tho that’s like $15 bucks for those that really struggle with this

Good video

Can you do a video where you have to use the end plate

Dang that set screw would have made life so much easier for me a few times 😂

Finally someone that doesn’t use a stupid tool to install a spring and detent I’ve been doing it kinda like that since the marine cops 3rd echelon shop, but trimming springs? I’ve never done that

Thanks man!
Simple and informative.

Please dont thread my holes daddy 🥺

Cool color

God I hoe no one’s loses those first 3 lol ….

Hey I’ve got the some lower but I bought it complete. Can you please do the same series but building the upper portion? (Upper, barrel, hand guard, etc)

Is the process the same for enhanced Lpks ?
I have one on the way and was planning to use these shorts to assemble my stripped lower

You trim the springs???