The follower spring I used was a Dmag shaped projectile 20rd (2pc) from MCS and is enough to do two TIPX magazines.
They also sell a standard feed version (roundball) that should work very well as well.
The latch spring as i said i will link once i have thoroughly tested and am satisfied it is the best solution if your balls are popping.
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
Just a thought, paintballs weigh far far less than defence rounds. One Jul likely weighs as much a 5 x paintballs, so the springs are probably working far outside the design specs.
👍
Another learning show🤓! Sweet💥💥💥
What you did with the ball latch for this truefeed will most likely need to be done with the Zeta's ball latch as well. Even with paintball which is much lighter than the ones you're using can fall out of the Zeta mag from whichever side is facing down. The spring for the latch is not that strong. It works well for shaped projectile though.
I tried the m17 spring but it seems that they dont 98% of the time dont always want to load when putting in the mag. Like i can put fresh full clip in look at breach hole and nothing. I love this marker an hate it at the same time lol
😎👍👍
Nice .. and a needed mod for those mags that's for sure
LLFD I need help with my tcr keeps leaking out the back can't figure it out think I messed up the regulator
I’m tired of my job I want to do this for a living 🤪