Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
Custom M&P 10, Magpul, Troy, and Nikon M-308 scope
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
cool bro, am on a same building in a DPMS 308, got the Troy's 13 inch hand guard, Vortex Viper scope, the Magpul PRS, Troy charging handle, Miculek compensator and still need to but some more stuff to get it done, yours looks very cool
how much does it weigh now that you have added all the extras?
Is your BCG finishing smooth?
Did you have any issues with the Low Profile .750 1" gas block?
you replace the gas block 😛
How can you get a Troy rail that long with a high-profile gas block on the MP10?
That's the best looking mp10 I've seen. Nice work!
Its great if ur using the 168grain hornedy but if u shoot a lot of random grain bullets its just ok 🙂
Yes that's the rail it was like $266.00 if I remeber and honestly the longest part of the swap was removing the delta ring over all swap time was about 30 min. A little tight with the stock barrel nut but I liked it better then the one that came with the rail. Remember to get the low profile dpms rail not the armalite ones or the HP dpms rail 🙂
Is that the MRF-308 rail? Were you able to use the stock barrel nut or did you have to use the supplied nut? How long did the swap take?