How to mount a riflescope in 60 seconds! #riflereviews #hunting
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
How to mount a riflescope in 60 seconds! #riflereviews #hunting
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
Brownells Discount Code: Bullets4Bucks
60 seconds with editing
Cool !
I just watched another YouTube video where the guy said don't use Loctite because it hardens, use "Vibra-Tite VC-3".
Anyone know what that level system is where i can get it
so many wrong things. red loctite is NEVER used, you torque the screws down slowly and evenly. You didn't set the ye relief
Install scope to rings tightening loosely. Then install rings onto pictinny. Be sure to push rings forward then tighten to base. Then loosen scope, level, level, level and tighten rings evenly
This would take a lot more than minute
I hand tighten everything never had nothing come loose
You did that all wrong!
Don't understand the level on the barrel??
Don’t fill the holes with loctite.
Put a tiny amount on the screws.
Plumb Bob the crosshairs?
Levels and torque wrench… bless your heart.
That is the proper way to do it.❤
After watching Paramount tactical, I have couple things to add 😂
I dont understand how the level works on the barrel.
how much in lb did you torque to the receiver?
Brother… Oil messes with the curing process of the loctite.
And that's why you take it to your local gunsmith
When do you set the eye relief?
The worst scope mounting video of ever seen lol.
Didn’t check eye relief, didn’t checked level, pour lock tight directly into the receiver holes lmao.
But hey, you used a torque screwdriver so,,, I guess your better then me.
Are you putting oil and then lock tight?
So you don't have to lap the rings? I thought you always had to.