➡️ The Most Comfortable Holster You Will Ever Wear. Shop The Best, Shop CrossBreed Holsters: (Affiliate Link)
How to remove the ejector from an AR 15 bolt for cleaning. Complete your BCG cleaning task by removing and cleaning the Ejector.
👍Get the Most Comfortable Holster you will ever wear!! (Crossbreed Holsters Affiliate Link)
⬇️Products Used in the Video are Listed Below.
Amazon Carries .223/5.56 Cleaning Supplies! Check it out (affiliate):
This is the most difficult part of Bolt Carrier Group Disassembly, but it is easy to do with the right tools and instructions!
Amazon affiliate links for the items used in the video (the channel may get a small commission at no cost to you if you make a purchase using these links and we greatly appreciate it!):
Real Avid Bench Block:
Real Avid Bench Block with Gun Punch Set:
Gun Punch Set:
Otis Gun Pipe Cleaners:
Hoppes No. 9 gun Cleaning Solvent:
Gun Solvent dispenser:
AR-15 Cleaning Mat:
************************************************************************************
FREE Resources from USCCA: (I highly recommend the Concealed Carry Gun Laws Map)
👌How to Choose the Best Firearm for YOU:
🤷Check out the Caliber Debate Video!! Which caliber is best for Concealed Carry?
👍GUN LAWS HAVE CHANGED! Get your FREE Concealed Carry Gun Laws & Reciprocity Map:
Billy’s Story:
***********************************************************************************
Check out the entire channel here:
See the Gun Blog:
All Content is Created & Owned by Reynom Media, LLC
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
The spring being removed from the bolt face…is it the same spring as a detent spring?
Nice.
Push the ejector pin in before removing the retaining pin.
1/16 punch seems too big in my supposedly mil spec bcg from to bear. Nothing but problems since getting this and in thinking now it’s been all bcg related
This helped me remove my ejector so I could headspace my rifle.
Nice. Thanks.
Thank you so much, but I have a question my gun was in a house fire, and a lot of stuff I replaced but my BCG seemed fine even the o-ring didn't melt, anyway somehow the ejector is sized flush to the bolt face I got the pi out but can't get the ejector out. Any ideas on how to get it out? Thanks alot in advance
Close-up, good commentary, and i feel more informed.
"… a small hammer" LoL. He brings out a prop from Ragnorok
Good video,
I had an ejector break and couldn't remove the pin this way. Ended up having to drill out the old pin. Replaced ejector and spring and new pin installed like the video.
Bad ass video..
This helped me unremove a JP 308 set
Great video 👍 thanks.
Aside from helping to thoroughly clean and inspect the bolt, it helped me too easily dissemble bolt for a headspace check.
Thanks, much appreciated
Nice. Anyone make a stronger ejector and or spring? They got plenty of upgrade extractor kits but don’t see or hear if any ejectors. I had a problem ejecting but it extracted ok
You’re Awesome! Thanx!! I don’t need to get that more expensive Master Bench Block. I can get this one you are using and continue watching this video when I need to do this.
This didn't work for me at all. My pin wouldn't come out. It came out half way then got stuck. I tried putting it back in and the pin got mangled. Now i can't put it back in. 🙂 This is great.
Great video!! Thank you for the detailed information!