Step-by-step instructions for installing the gas system on an AR-15 upper receiver.
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
Good for a fun gun, not for serious use. Barrel should be dimpled if using set screws along with rockset (NOT loctite) and the gas block should be properly spaced from the shoulder. Preferrably, a taper pin to secure the gas block is best.
👍🏻👏🏻Do you not recommend using some sort of thread tightener or is that not needed with the brand your using?
Now the barrel nut?
Thanks this will come useful as an uk citizen with our ar 15s without a gas system
So simple with your video.. Now if you leave one set screw out over the gas port on the barrel it will show you a perfect alignment with the gas tube hole. From another vid. thank you. Usually now its a bit off that stopper of the barrel like an 1/8 of an inch short of that barrel stopper so put it on properly if you wish.
But yall made it so simple and easy I thank you.