How to assemble AR15 lower receiver from scratch
Parts can be found at
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
Welcome!Log into your account
I like to drill and tap the bolt catch hole instead of using the pin
Fantastic job ,thank you for video.
Can’t see didly. Pass
How the heck did you get a Daniel Defense pistol grip without the trigger guard???
What’s the name of your vise set up
Thanks for your time sir. Along with the knowledge you've shared.
I don’t see the link to this build
No. That’s not “all there is to it.” The magazine release is supposed to be screwed down until the button is flush or below the fencing around it. Not just until it “doesn’t come out the other side” when you weakly push it. (His button is awfully proud of the fencing) And the castle nut is to be torqued to 40 Ft-lbs.
Excellent instructions! Thank you so much for taking the time to show me
The castle nut requires 40 foot pounds of torque.
Very well done Brother. Just subscribed!!!
Jc