Home CMMG CMMG 10mm Banshee Review

CMMG 10mm Banshee Review

573
38

Note: We were filming in a safe location(s).

Today on Alaskan Ballistics, we’re shooting and reviewing the @CMMG Banshee 10mm. We’re testing reliability and Accuracy!

Support Alaskan Ballistics on Patreon:

Alaskan Ballistics T Shirts and Hoodies:

Three Pigeons just sent this awesome range bag for review.
@threepigeons
check them out here:
Discount Code: 10%OFFCODE

🔥🔥🔥👉 Affiliate Links to the Cool Stuff on MeWe: 🔥🔥🔥🔥🔥

My Affiliate Links that Are Allowed on youtube:

ParaKito Mosquito Repellents:

TideWe Clothes Blinds and Packs –

️Tacticon Protective Gear –

Pro Ear Hearing Protection

MIRA SAFETY –

– RMA DEFENSE BODY ARMOR

Scentlock – Clothing andHunting Scent Products

Shall Not Comply! Now Tri-Star Trading!

Spartan Armor ARES LEVEL IV PLATE:

Simms Fishing Gear

Survivor Water

National Body Armor

Kelty Backpacks and Gear

Rapid Medical Supplies

Auguson Farms Food Storage

**Check out the Rest of my Affiliate lInks on MeWe:**

Watch My Classical Music Channel:

BlackBeardFire Starters Discount Code “Alaskan”

Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.

38 COMMENTS

  1. Not grouping the 200 grain bullets is a heart breaker. Maybe when/if they offer a barrel with a faster twist for heavier loads they will re engineer and optimize the angle of the locking lugs and adjust the buffer/carrier weight making the “10mm heavy” model a well rounded woods gun. We can only hope they see it as a project worth taking on.

  2. Underwood Xtreme defense and penetrator. Liberty overwatch is what i would like to see tested. Both chrono and shot into maybe rib meat and water or something behind it. Really thinking about this for the wife as a home defense go to in 10mm.

  3. Bought one of the early models and I found that "if" you suppress it and set it up accordingly the Banshee works much better. Just my experienced though. BTW: Running S&B 10mm 180grn with eleven grains of who knows what powder.I also built a 45 ACP Banshee from parts and I find I get great performance with it (built the proper way) running 230 ball with Unique.

  4. That’s awesome! Thanks for testing. Not sure if you can do it but would be cool to get your take on this one vs Chuke’s striborg (unless he sold it already). Lol. You said that at the end. Looking forward to the series!!

  5. Check your casings! Especially the underwood 165s! When I bought mine, I immediately put the 8oz buffer in it per instruction manual. Shoots Blazer Brass and Magtech 180s just fine. Zeroed my red dot with Underwood’s 165 Gold Dots and discovered cracked, split and bulged cases! I believe for these awesome 10mm loads, the firearm needs a roller delayed system. No ammo issues from my XTEN and XTEN Comp.

  6. 200 grain hardcast Underwood vs Buffalo Bore please! (Aww, nuts, I should’ve watched before commenting, you did do the Underwood hardcast. Cool! Too bad it’s all over the board.)

  7. Very nice. I’ve got mine setup with a Romeo 5 and a pelican light. My 45 sgm mags work very good. Mine was to tight from the factory. Jammed the first 20 mags and finally ran smooth. Great little pistols just expensive.

Leave a Reply