Best Kept Amazon Iron Sights Secret

THANKS… ORDERED A SET 👍

I bought these sights and at first they worked great at first. I did find after some time the front sight post would work themselves low. I would reset the front sight and after 8-10 mags would be pretty far out. I decided to hot melt the tool less adjustment and the post itself and it was fine after that. Should I have just sent them back probably. After this particular example I would not buy again. Good review my example was just a bit off.

Thanks, just need to tape off and spray paint off that blaze white logo

Can the rear site be used with a front blade site on a shotgun?

This review immediately returned the Ozarks and ordered these.

made in china 👎

Do you have a video on the red dot? How do you like it?

My set screw tends to loosen up or if I screw it in a little tight the post doesn't move.

Can you do a video on how to use these sights?

Torn between these and the Feyachi's. Do they hold zero well?

I’m sure they work. But they’re hideous.

red dot model and brand ?

So are you saying you can adjust the sight with the knob and then lock the adjustment in with a tool?

Thank you for the video. I just order a pair of magpul sights and when I received them I was disappointed that they were polymer and stiff to work. Have these performed well for you over time?

Just something I discovered you need to loosen the set screw on the front site in order to be able to adjust up-and-down movement with the thumb knob, I keep the set screw just tight enough to keep the optic from turning left or right

Hi, can you tell me the model number for the red dot you used for this video. Thanks.

Votatu makes low profile laser/lights too (I have an M9L-G) and they're amazing for the money. Laser holds zero on 5.56, light is bright as fuck, doesn't mind heat, passes "the hammer test", and magenetic charging all for under $60. Votatu in general is just super slept on because they're prices are low lol

Will these sights work for any red dot? If I mounted a Sightmark M Spec?

Good to see the iron sights, front and rear, work together with the optics.
I guess, that the optic is a Romeo 05.

Teach me.

Thank you.

I was about to reluctantly spend a lot more for new sights until I saw this video. Thanks!

I bought these and the rear sight couldn't be installed because they machined the base backwards. Basically one side was completely flat meaning there was no lip to be able to clamp against the pic rail. Outside of that, it seemed nice. Only downside, other than by QC was that you couldn't just fold down sights without holding the button down. Not sure if I want to change getting a bad sight again.. Might just bit the bullet get get the Magpul MBUS sights.

People on Amazon saying the rear aperture sight is on backwards, OMG!!!! 🤣

I'll buy the American ones. You still are better. I feel better people here know how to make them

Three months later, how have they held up?

can you recommend a decent red dot at $100 or less that can cowitness with these sights? not sure if they even can but i saw you shooting through them with your red dot so how are they for that functionality?

I just bought some, hope they work!

CHINESE MADE!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!

Do they make a 45° offset version? The only ones I can find that our comparable require a tool for the front, usually not included.

I have a pair. Only thing I do not like about them is the fiber bundles on the rear are not aligned evenly.

What is the red dot on the rifle?

The button that flips them up seems like a snag problem.

Nice find. Thanks for the review.

Just ordered me some, thank you!

Aperture sights are horrible.

I bought a set of these sights and love them. They are the next best thing to sliced bread on an AR.

Cool, … are they standard height same as millspec iron sights non flip??