DISCLAIMER:
I am in no way encouraging or advising anyone viewing this video to attempt to modify their firearms. I am NOT a professional gunsmith! If you are not 100% confident in your ability to modify firearm components AND well experienced, DO NOT even attempt it! Always seek a professional gunsmith if there is any doubt!
I am releasing all my CAD files for my gun parts designs. There are all up on GradCAD right now. There are parts for Polymer80 pistols, HK P30, CZ Scorpion, a Streamlight pressure pad mount, and a magazine rack and hanger system. Please do not print these to sell them. But please do print them to test them out on your guns and give them to your friends and family. Thanks for being apart of my little tiny YouTube community.
00:00 Introduction
02:13 Polymer80 pistol mag wells
06:31 HK P30 mag well
07:37 CZ Scorpion trigger and safety
08:59 Streamlight M-lok pressure pad mount
09:50 Magazine racks
11:25 Conclusion
My GrabCAD Model Page:
Polymer80 video:
HK P30 video:
CZ Scorpion video:
Magazine rack video:
Hardware for the 3D printed parts:
Tungsten fishing weights 1/4oz:
M5 short heat set inserts:
M5x12mm button head screws:
Soldering iron tips:
Soldering iron
M5 12mm long flange screws for Mag holders:
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
I really appreciate that you released the files because I loved your design for the P30 magwell