Time to install JP’s new rifle length gas, 18″ barrel.
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
Time to install JP’s new rifle length gas, 18″ barrel.
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
Came here to learn how to install… wasn't shown anything
You should be torturing with the head at a 90 degree parallel to the handle, otherwise it will over tourqe. Good video though thank you
What upper receiver vice block did you use?
Real nice rig.Its set up real nice.The hand guard is Killer.And a nice barrel to boot.Ive not seen the Lucas oil for guns.Where did you purchase it?
What make handguard?
I just bought a no barrel and it did not come with a barrel nut where did you get yours?
Does the comp come canted from the factory?
Does that Carbon Arms handguard have a spot to mount a sling swivel? Bipod?
SO I got a JP .223 16" barrel. I installed it, I even got a JP BCG. I took it out to shoot. The first round I chambered and fired. It failed to extract. I tried to extract it by pulling the charging handle and It was so stuck in there. I had to kick the side charger to free it. I chambered a new round and it got stuck. Any ideas of what is going on here?
Do you recommend pinning the JP Gasblocks or are the set screws sturdy enough for competition use?