This video is about AR-15 – Receiver Extension and Takedown Pin Installation
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
AR-15 – Receiver Extension and Takedown Pin Installation
You torqued the castle nut over 40 ft/lb. The way you had the wrench essentially lengthened your torque wrench without recalibrating the internals. You have to have the castle nut tool exactly 90 degrees off the side of the torque wrench head or it’s not accurate.
Doubt you'll get this but which way did you put the detent pin in? I just want to make sure I saw that right. I had to rewind and watch that twice just to make sure I saw what you did. If what you did was intentional, what's your reason for it?
what's the idea behind putting aero shell grease on the buffer tube?
All 'em duck parts…
You are the BEST
Excellent
Buddy plz start using tools with ur torque wrench at 90 degrees…that's the proper way to use a torque wrench without taking the torque out of spec
Can I get a part list ?
The Geissele MCMR barrel nut wrench works on castle nuts and I think it works great. Allows you to stay close to the work piece.
Great video. Keep up the awesome work.
I THOUGHT YOU DIED WTF?? SOOOOO f****ng glad to see you back! I rarely come on youtube and didn’t notice your uploads until now.
question. how do you feel about the buffer retainer some people dont install it ie forgotten weapons
Love seeing your vids again. Reminds me of the good old days when I built my first ARs.
Youtube and google are just plain bullshit nowadays.
Would you say forward controls is HK quality at PSA price?
🌟👍🇺🇦
These tools by forward controls look pretty awesome. I like the gas block tool that is very useful
these videos came in so clutch for me. i have a few psa lowers im building and been kind of hesitant because my eyes are not the best , these are going to help out so much thank you!