Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
How-To: Assemble an AR platform lower receiver. No special tools.
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
Ordering Tomorrow And This Will Be My GO TO VIDEO 👌👌
Great job!
You must me a teacher in your other life!
My favorite parts are when you say "hold on this is being……whatever" (I don't feel bad when I hit a snag there as well)
There are lower videos that run 7-10min. (not for a first timer)
I've watched (paused, rewound ) your video at least 10 times.
Very well done, Thank you!
Awesome job sir!! helped me out a lot!!
Honestly the best lower video I’ve been able to find, thanks for helping me build my first AR!!
Very helpful review. Nicely done.
Video is very much appreciated. I do have a pointer to throw your way. When you're installing the buffer tube, and are ready to insert the detent and spring for the rear take down pin, simply tighten your castle nut down to touch your plate to the razor blade prior to pulling the blade off the spring. That will stop your spring from having any room to wiggle out like they do.
By far the best video on assembling a lower I've seen. Very detailed. I'm getting ready to assembly my first one with the Palmetto lower kit and this was very helpful. Thank you!
What do you know THANK YOU for your intuitive attention to detail as for lighting and parts orientation and video clarity REALLY BIG THANK YOU
Nice video SD – keep up the good work :)🔥
I've built about 6 lowers. I got tired of worrying about breaking off the tab over the rear of the trigger guard so I found a pack of hex screws on Amazon and just put one on each side of the guard. Makes it alot easier. Thanks for the video. Love the channel.
Please dont get banned and back up your videos i like them