Giving Review of my Lower receiver produced by Del-ton. CMMG lpk. Stag arms buffer assembly. And yes I do have two(2) receiver end plates installed one is standard and the other has the sling swivel a
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
Psa has the best triggers out the box but DelTon just looks better.
I am a Proud Owner of a Delton dti 1×9 twist 556 NATO Complete Uper I would like to get the delton lower reciver when the time is wright I like missions been a action junkie for a long time lol😁
Now all you like is the rest of the gun…..
No review…Del ton gets a bad rap from its early years production runs as well as their budget entry ARs-which better than rock river and bushmaster offerings, but the lowers are in spec and same material and finish as my BCM and LMT lowers. Del Ton sadly offers more costly upgrades that come standard in Colt, BCM, Spikes offerings….
I saw a striped Delton lower today and was not impress with the quality. Since I didn't have my gauge with me at the time and wasn't able to check dimension against the published blue print, I can't vouch for how precise the machining job. However, I did notice all the machined edges were not as sharp as other lowers I have seen, this typically mean the lower was heavily tumbled after it was machined due to poorly controlled milling feed rate. For minor price differences, I'll pass..
uhm…….. where is the "review" here? (O_o)
It is a forged aluminum receiver. Del-ton does not make poly lowers.