Home CMMG Ballistic Advantage Builder Series: Install the Rear Takedown Pin, Buffer Retaining Spring...

Ballistic Advantage Builder Series: Install the Rear Takedown Pin, Buffer Retaining Spring and Pin

971
16

Today, join Clint as he installs the Rear Takedown Pin and Buffer Retaining Spring and Pin.

Enjoy.

Check out our awesome sub-MOA Guarantee barrels!

Need a receiver set?

Need parts?

Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.

16 COMMENTS

  1. What the fuck? How did you get that asshole spring to go in the fucking hole? I have lost 3 trying to fix this piece of shit, and waisted 20$ ordering new springs. They go in so far, get kinked, then when I touch them, they fly off to another fucking dimension somewhere. Fuck my life, is all I can say. I swear, if I didn't like it so much, I would throw this fucking gun over the fucking mountain.

  2. Best assembly video I have seen. If I would have watched this instead of another one, I would have had a lot less cursing and frustration. Thank you!

  3. Take a 4-40 tap when tap hole for the rear take down pin spring hole. Take the spring using wire cutters cut about 1/8'' off spring. Then put in take down pin, detent, spring. Use a 4-40 -1/8 set grub screw and you'll never have to mess with the spring again.

  4. Clint, your AP-parts and your tutorials are so top-notch and helpful. Since I watched this vid and was successful at "sticking" this, I've shown it to a couple of builder-buddies. They are impressed with the quality of your parts and product-line.

  5. I suggest turning buffer tube to the right side a bit then iserting the latch pin spring, return to position and usin a sma.ll screwdriver to ailing with latch plate and push in then tighten castle nut

  6. Great job,I been watching since the beginning, I recently purchased a ballistic advantage lower receiver, right after that I found your channel ,I love the receiver,personally it's one of the top receivers. Thanks for the channel and the build!

Leave a Reply