Assembling my buddy’s Stag Arms stripped lower reciever with a DPMS parts kit.
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
Assembling my buddy’s Stag Arms stripped lower reciever with a DPMS parts kit.
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
Where did you get that chart that you have all your parts on?
My god man…
That was brutal. Lol
I've found that if you put the trigger guard in and then start driving the roll pin through and you just support it from underneath you won't run into any problems, it basically supports the inside for you. But you still want to support it from the bottom. It makes the process a bit faster and more care free.
Lol…rugged, thanks for watching.
When you were pounding on the lower received while installing the trigger guard before you had the guard in place to start the roll ping, I was holding my breath… lol I have heard, watched and read about so many horror stories about breaking it off if it's not supported! good video!