Home EOTech Changing My EOTech 552 REPLICA To A New Holoscope (Airsoft)

Changing My EOTech 552 REPLICA To A New Holoscope (Airsoft)

617
8

My 467th Video
35 in HD

After being so well pleased with a LOW COST holosight I found on eBay that I used on my Magpul PDR, I decided to change the replica EOTech 552 to the same on my KWA KM4 SR10. It features four sight apertures, and red or green adjustable brightness dots or crosses.
And it does NOT get flushed out in direct sunlight.

Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.

8 COMMENTS

  1. Ur stance is horrible
    No offense
    Get that arm tucked in and lean a bit forward
    It’s for a better shot and easier when u run
    Trust me I’m only 13 and I’ve been playing for 3 years and I used to have that problem too
    It’s bad because someone shooting at u can easily shoot ur elbow because it will be tucked out
    And u might wanna tighten that motor baseplate screw
    It sounds a bit screechey
    It will hurt ur gears and u can have a better response if u put a gate titan in there
    There’s my 2 cents

Leave a Reply