This is the first in a series of videos chronicling my assembly of an AR10 or LR308 type rifle. It will be using and 18″ barrel and set up like a carbine.
Viewers use the information from this video at your own risk. YAA is not responsible for any injuries or damages as a result of using any of the ideas or information presented in this video.
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
i wanted to see how you installed it, instead you skipped over it.
the reason your steel magazine doesn't fit is because it's for an AR-10B lower receiver and the Aero receiver you have is the modern AR-10A
Tough getting a good block of time. I did paint one time through but I need to adjust my technique some and redo a little. The first go left a slight bit too much sheen. I was recommended to back the can further away and use the blow dryer.
Got the parts painted but now I need to summarize and edit together. Part 2 almost there.
Maybe get to tge parts painting this weekend.
Checkout my subscriber promotion video. I have a small giveaway offer.