Link to purchase the scope if you want to or just check out the exact specs:
Overall I think this is a great little scope for the money you spend. There are many other options out there and I’m interested in them as well. I need to venture out and by some other brands. I just like vortex and have had very good experiences with their products so I keep buying them.
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
You just put a loaded gun in your truck, not cool!
forgot to say, now your bolt will run slipperier than puppy poop !!!!!!
Those "long" 25 rnd. after market mags, if the slight bit loose/wiggley after inserting, will cause jams. your gun should work in cold weather. { Take the bolt out of the gun, rub it down with "very fine" steel wool, Any place where it rubs another suface; also the inside of the receiver any place there are parts that have other parts that touch them while gun is fired.
Now, blow them off with canned air, {have frog lube on hand & small clean 100% cotton tee-shirt scraps} heat the bolt with hair dryer, apply just enough frog lube to coat it{don't gobb it on, don't get it near where the firing pin channel} put it down, heat the inside of the receiver, apply frog lube again. Pick up the bolt, rub " EVERY SINGLE BIT" of the frog lube off the bolt. & the same with the inside of the receiver, every bit. (leaving some in is bad a rookie mistake)
You have to bush up the mag or mag well with something like layers of duct tape or some other kind of tape. {add one layer at a time, then check after each layer, for correct fit}
I highly recommend taping the mag , NOT the mag "well" . Other mags { like the 10/22 10 rounders will probably work without bushing. Hope this helps.
Nice Video, liked & subscribed.
AWESOME
$159 on cameralandny.com
I have sane issue with federal …. since I started to use CCI I almost never had a problem….
i use this optic on my ar-10 lol
Did you get the low height or medium height rings? I just bought those same rings for the Diamondback 2-7×35 and I went up to medium because I wasn't sure if I was going to be able to clear the factory rear sight with low ones.
Nice .22
what mount are you using?
nice scope! the mount is a DNZ mount and that seems like A lot of magnification for a 22
Do you like this or the Leupold better?