Carbine Length is Made in the US. Four-sided, mil-spec picatinny railed handguard allows for a huge array of accessories and is precision machined for maximum strength.
Two piece design replaces your original plastic handguards and locks in place for a secure fit. Installs easily without gunsmithing or modification to the barrel.
Includes rubber rail guards for comfort and protection.
Hard anodized aluminum construction for superior wear resistance. Four rails with 14 slots per rail.
Fits carbine length M4 and AR-15 style rifles.
Carbine:
Carbine with FSP cut:
Mid-Length:
Rifle:
DPMS Claw:
Hand guard Removal Tool:
Music by: Kevin Macleod
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
You can just be a man and use your hands?
its look like a sbr
its look like a sbr
Who uses a hand guard removal tool? You can do all of this with just your hands and the quad rail, you don’t need the tools
Very nice! How can I find one for my ar? It's a bushmaster. When I bought it they said it was a bushmaster qrc (quick ready carbine) and it came with a red dot optic. Just wanting to make sure I get the proper fit on it
anyone know how to get the picatinnay rail off the hand rail! removed sperical nut, but bolt won't push upwards through! starting to get pissed, wanna finish this build!
was a very helpful step by step video
looking for one of these in plastic/polymer any suggestions and if possible would you know the weight of one in polymer
will this fit on a fn15 carbine?
Will it fit a m&p sport 15 II ?
I installed mine with just a freaking screw driver none of that other crap was needed wtf people
would this rail for the rugger ar556?
You forgot your safety glasses and ear protection.
nice video but I didn't need to do all that but this was alot easier
Just got mine in the mail. Installed start to finish in about ten min. Solid construction and good look. Cant wait to shoot now.
Cheaper than dirt my ass lol !!
What utg Model number are u putting on your rifle? not the Arr-238. Thanks
utg= junk
Is the AAR-157 Adams Arms Gas Block compatible?
Good infor, thank!
I'm using an Adams Arms 16 Carbine upper, I'm assuming that this "6.7 handguard" will directly replace my plastic 7 inch handguards?
Do you have to take off the charging handle and take out the carrier group or is that just something you did
If you have a newer weapon with a stiff spring under the delta ring (or a handguard that fights being installed easily), that delta ring tool can be mighty darn useful. Doesn’t cost much and saves a little effort, so why not use it? I wouldn’t buy the vise block (never needed one), but I guess roughly the same could be said for it.
I agree with comments about the handguard removal tool and vice…totally unnecessary.
Don't need the Delta Ring tool either. I have these things called fingers & they work just fine. I think this is one of those Government propaganda videos, you know the ones. They say I NEED IT, so it MUST BE TRUE!?! LMAO
Why the heck do you need that silly vise set-up?!? I think it's a money-sink for the, "OMG I can't do this (simple swap) without that", impaired.
Does any one know what a good quad rail is that will fit the bushmaster 20" Flat Top National Target Match rifle?
would the carbine work on my m&p 15 sport
Is it ok to mount a front MBUS sight on this thing or should I go with a free float system for that?
I am wondering the same thing! Did you find out?
Cheaper than dirt, always trying to make a buck.