Home CMMG The effect of barrel length on bullet velocity

The effect of barrel length on bullet velocity

2
28
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.

28 COMMENTS

  1. The central nervous system cannot tell the difference between 2,100 FPS and 3,100 FPS that being said the 5.56 is absolutely intended to use velocity for its lethality in combat.

    Plenty of big game animals 🦌 have been dropped by a .22LR even the bipedal ones 👀

  2. Most engagements don’t require a 16+ inch barrel especially in urban areas that 16+ barrel could hinder the operator 11.5 really is the sweet spot and enough training and knowledge of your 11.5 long targets are no challenge anything more than a 14.5 might as well get a 20” upper to carry swap the upper out

  3. Who Gives a Fuk about velocity in a AR15 ? If you want velocity plus distance you’d definitely use a different Tool.

    Want short distance stopping Power use a Shotgun

    7.5 AR15 is ideal for smaller vehicle carry because it uses ammunition that isn’t an arm n leg & u can find it almost anywhere.

    Plenty of Videos out there where Good shooters show hitting targets at 300yds in the A zone with just a Red Dot with a 7.5 AR

    Just food for thought but most importantly go out there & Train. 🤙🏼

  4. 556 was designed to get it’s optimum performance out of a 20 inch barrel. 14.5 inch barrels are a compromise between portability in close quarters and performance. 556 especially in the 50 grain loads loses it’s shocking impact going shorter than 18 inches. For short barrels 300 Blackout is a better round. You can use subsonic loads and you have a heavier bullet. It’s quite effective at clearing buildings and for street fighting at closer distances. I run 300 Blackout when I go shorter than 14.5. 24 inches with 556 reaches out and does a number on varmints.

Leave a Reply