In this comprehensive tutorial, we guide you through the process of assembly of the AR15. Learn the exact tools you’ll need and detailed instructions to successfully assemble the AR15.
00:00 Introduction
00:14 Mag Release Install
02:06 Trigger Guard
05:33 Bolt Catch Release
09:05 Safety Selector
11:46 Pivot Pin
14:04 Buffer Tube
22:58 Upper Receiver
23:33 Ejection Port Cover
26:24 Upper Receiver Lapping
28:42 Gas Block & Tube
31:54 Barrel Install
42:59 Handguard
44:07 Muzzle Device
45:49 Charging Handle and BCG
Tools in the video.
The links below contain affiliate links which may provide a small commission to the channel. This is no way adds to the cost of your purchase.
Fix It Sticks:
USE COUPON CODE: armedlifestyle for 10% off
Gas block jig: Amazon:
Wheeler Trigger Guard Install Tool:
Brownells:
Amazon:
Roll pin starter punches:
Brownells:
Amazon –
Delta Series AR Pivot Pin Installation Tool :
Brownells:
Amazon (Real Avid version)
Armorers Wrench:
Brownells:
Amazon:
Wheeler Upper Vise: Brownells:
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
38:40 GASSHOLE!!!!
Trigger assembly?
You didn't get the trigger assembly in the video
Do not follow this video and never put lapping compound on your receiver, It will destroy it… When you push the tool in it will pickup the compound and grind away the surface where the BCG slides… Only put the compound on the small shoulder where it meets the upper… Be sure to remove any speck of the compound that may have gotten inside the receiver.
When did the trigger get put in, also the safety sector pin shouldn't be tight going in I'm guessing.. mine is very tight. I'm using an 80% lower. Tia
Dude – you completely skipped over the trigger assembly/install!
Hi, you did not provide a link for the "fix it stick"