Simple Hacks to Prevent Your Bolt Carrier from Getting Stuck

my issue is my bcg wont go all the way back. is an H3 buffer too much?

You also can shave the top of the lever
I’ve found this better because I was using soft tips and it would jam I took out the quarters and shaved the lever now it runs any type of ammonia I even mixed up six different types 223 556 different grains soft lead all worked

Run it wet with lube like a prom date

Can you do a hydraulic buffer ar9 super safety visualization ?

Kynshot rb5007, 5” barrel, yellow spring

Great hack. It’s the only problem i’ve had with mine although it only stuck open once in 150 rds it does it a lot while dry testing. I am about to go put another 150 rds but trying a couple of quarters. But can i use 4 dines and two nickels i stead? 😎

Two quarters saved me. I recently installed an atrius super selektor and was having this exact issue after about 120 rounds, threw in 50 cents and fixed the problem

I’m having an issue where my super safety only functions in semi auto mode even when in the third position, (no forced reset) I purchased a pre-cut trigger and I’m still having the same issue

What about dremeling the tab of metal on the upper just above where the takedown pin goes through?

How to get it in jam?

I had to do the quarter thing with a 9mm ar

My 300blk 4.5 upper was doing these I got new H3 buffer and added the coins but after every shoot I have to manually keep on charging handle

had this issue with my blackout defense quantum DTL 14 in 556. got a Geissele super 42 with an h2 buffer and now it runs great. there also on sale right now on primary arms.

I have one in my ar9 I have an a2 buffer that i removed the steel spacer out of and added three more weights from a carbine buffer. I swear it’s the lightest recoiling at 9 I’ve ever shot. With a super safety I can dump a mag and the gun won’t move.

How many quarters do i add

I have a standard M16 BCG in my AR15, do I need to buy a full auto BCG? Thanks.

What if the lever doesn't rotate far enough with the upper on?

The quarters fixed my issue thats exactly where mine was hanging up.😂😊

My bolt seems to be getting stuck to the rear after trying to rack it. I installed SS and H3 buffer kit. What could be the issue? Ss functions properly and I lubed the Bcg as well

Could this be the issue with my 7.62 upper? I have the correct BCG but it would fire one shot and then get stuck all the way back and I had to push it back down into battery, almost felt as if it was getting caught and was gonna break it.

Had the same issue while dry firing it. I was going crazy trying to figure out how to get it unstuck. I got a small rubber mallet and tapped it on the side to get the bolt forward again

If your super saftey doesnt go back far enough how much material do you need to remove from rear of lower is there too much?

The quarters were in my build with my ss kit took them out only to find it no longer worked anymore just to have to replace them!

I tried both options and did them together aswell didn’t work for me

Had issues with my SS, found your troubleshooting video showing my exact issue, got an h3 buffer and it works amazingly now, thank you

Bro no way it worked fr

Great channel, your explanations and video demonstrations.
Are top notch and help so many people understand the function.
I especially liked the other one about the SS.
Thank you sir.

Straight from SOTAR. lol Be sure to measure the gap between the carrier key and the lower receiver.

Great vid