Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
Part 2 Free float handguard installation #diy
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
All that work for an ugly setup. Hope it shoots like a dream.
How do you line the gas port up to the hole on the barrel easily?
Locktite?
Now screw it down and twerk it
There was a massive gap between barrel and gasblock I hope it runs well.
You need at least Red loctite
Why such a short handguard for such a long barrel
1. Don't reuse roll pins.
2. Blue loktite is useless at gas block temperatures.
3. Use knurled cup screws with gas block. Also simple the barrel.
Lol. Blue thread lock on a gas block. Why not just use some scotch tape?
Pretty
Magnets and painters tape I love it. It’s practical
Okay… i can somewhat understand the white lightning for the barrel nut to help protect from siezing, even though anti-sieze would have been a better choice. But the white lightning on the gas tube pin? XD wtf are you doing man?
Drill dimples into barrel for gas’s block bolts and stake em or that gas block will walk…
I thought YouTube didn’t allow these kinds of videos anymore
Why the FUCK would you put blue locktite on those screws 😭😭😭😭
Bruh, needle nose pliers for gas tube roll pin
Literally game changer
always torque at 90 degrees with an adapter or wrench for accurate torque. Stop using a claw hammer to hit a punch. Other than that good job
Midwest industries makes great hand guards. Been running one for about 2 years now
If only the roll pin went in that easily
Throughout that worthless birdcage this isn't the 90s.
That AR Stoner hand guard
Hand guard is wayyy too short, at least try to get it close to the barrel threads bud
Do you have to stake the gasblock?
Do some free float handguards not come with little guide pins in the top that fit to either side of the upper? They make it so you don’t have to align the guard by hand the upper will just slide between the pins
BLUE loctite? Seriously? For a gas block? RED dude
I think this upgrade is a little too extensive for a 30-second clip
Makes it look so easy
Happy little gas block
Twerk it to about 35 foot pounds
Why’d you have to go and make it ugly like that
I like float hand guards but if you wanna run a magnifier or anything in addition to a red dot you can't because the hand guards will cause the sight to come out of sight.
Good setup… get yourself a starter punch and a puck, we degreased all threads with acetone. And use rock set on gas block screws. The blue licorice will cook and break
It's always somebody that wants to say something about a video but probably can't do nothing this man done it looks ok to me it's not the looks it's how it shoots.
Rockset is what you want on on that gasblock. If you never want to take it off again without headache you can also do what I've done a couple times. You take a punch and stake it with a punch on the sides of the screw hole.
The barrel nut….
The absolute bane of younger me…
Yup just twerk it down 😂
Excellent video, but that's a bit too much hard work for me.
We might be soul mates dude … I love building …😂❤
Adding blue loctite converts it to a fully semiautomatic assault weapon.
Neet gun but i realy like that torque wrench adapter thingy
Ehy such a short hanguard. U have a sbr handguard on a full length setup