
This is the steps I take to bore sight a bolt action rifle.
#shorts #shooting #shortsvideo
Email- Contact me here
joe@hopefulremnant.com
My website
Patreon- If you’d like to support me on the internet
I’m also on Facebook
I’m also on Rumble
Check out my Amazon Store
Hopeful Remnant is on YouTube
Hopeful Remnant is on TikTok
Hopeful Remnant is on Instagram
Hopeful Remnant is on X
Hopeful Remnant is on Rumble
Hopeful Remnant is on Locals
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.



Great video. Just make sure you shoot a little low at 25yds. If not it will be way high at 100.
never seen that type of boresight but helpful thx
Do it in the kitchen, shine a light down the barrle at the wall then zoom in your sights to the light.
Good information 👍 👌 👏
That looks like a Boyd’s stock, nice.
I Like ,22 bore rifle,
Only works if you can get to your bore like that. Try doing that with an ar or an ak. But all in all its a cool trick.
I did it at 100' bore sighted at the target put the by back in shot then adjusted the scope till it was over the bullet hole. Super easy.
Does the orientation of the stuff to set the direction goes with the distance of the impact . Should have a laser in the pipe and a two eyes loop
I mean, kinda
Insane power
That's how I do it. No fancy laser pointer needed
When moving scope to target , turn turret opposite direction (up is down and left is right)
I use a old boresight from the 90s. Works good for me.
Captain: there is the target at 12 o'clock sergeant
Sergeant:
Missing the center at 25 yards should be considered a sin 😂
Now doit in meters
I always boresight my rifles at 50 yards. Had good luck doing that. Whenever I get to the range, I'm only off usually a couple of inches at 50 yards.
You can also boresight on a spot much closer. To boresight on a spot 5 yards away like you might find indoors, measure the height of the center of your scope over the center of your bore and sight the scope to a spot offset by that height.
Next episode. How to pull the trigger….
I do the same thing only at 100 yds and I’m usually 6” low and slightly left first shot
Down three clicks windage two clicks right.
Yes works with any bolt action rifle only
Put a laser pen in the barrel and you got the exact point where you aiming
MOA 🤢
laser bore sighters are so so nice
You just sighted in a rifle for 25 yards 😂
Bore sight your rifle at 33 yards. Shoot once. Adjust windage and elevation clicks X's 3. Now you are on paper at 100 yards with only 1 shot.😮
All fun n games till its a ruger 1022😂