Home CMMG DIY AR15 5oz Carbon Fiber Lightweight 12″ Handguard (140g)

DIY AR15 5oz Carbon Fiber Lightweight 12″ Handguard (140g)

398
32

I made this using a YHM style barrel nut turned down for a press fit, a 3D printed clamp, and this carbon tube: (5287T25)

Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.

32 COMMENTS

  1. Great job bud… The company I purchased my Carbon Fiber Upper discontinued them and I wanted to build a pistol version of my rifle. Unfortunately finding a similar handguard is very tough. I'm about to order an octagonal tube and do all the mlok holes myself with a dremel. I've worked CF before, but finding a barrel nut that will accept this octagon shape is going to be tough as shit

  2. I am building one in a 5" pistol barrel length. I can only find the tube in 4 In or 9 in tubes. Could I buy the 9in tube and cut it down to about 6.5 in to cover the Gas block and flash can?

  3. YOU SIR… HAVE SHOWN ME EXACTLY WHAT I WANTED TO SEE IN THE 1ST VIDEO I'VE EVER WATCHED ON THE SUBJECT… In your opinion, what mm should the ideal thickness be for a build that's something like you just showed in your video? You're the best!
    THANK YOU SO VERY MUCH!!!

  4. cool stuff man, I am looking to do a feather weight build myself and this seems a lot better option than buying a $300 rail or China-men "carbon fiber" "keymod" handguard from eBay that is probably all kinds of fucked up. Thanks for sharing.

  5. Btw, you should 3d print or machine a clamp with a built-in rail section where the screws are, that would allow mounting a bipod when you want without adding to the weight when you dont. Even if it is pretty far back, the lightweight barrel I figure should help make that work.

  6. Feel you on the astigmatism, I found the magnified ones work perfectly for me while the 1x ones are just a fuzzy red cloud. Had a truglo el-cheapo 2x and it was perfectly focused. Upgraded to a 3x from Burris and that's even better, nothing short of amazing. The only thing you give up due to magnification is the cowitness, but with a qd rail mount on the red dot it's not an issue.

  7. I think you just made my mind up on what I'll be doing for my dolos pistol build. I think I'll try and do what you done here, or at least very similarly. The dolos gen 2 works with yhm barrel nuts so I think I'll be set. thanks for the video.

Leave a Reply