I walk you through the simple process of upgrading your trigger with this amazing drop in 3.5lb pull, flat front trigger by CMC Triggers!
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
Thanks for the video! I just purchased this trigger and ecited to use it at this weekend's Patriot Games. Mil-Spec trigger had to go.
Thanks for the vid!
I recently purchased a complete DPMS LR308 lower from FIREARMS UNKNOWN” in Yuma, Arizona. attached a 24” 308 win upper and took it out for a test. The hammer strike was extremely light and the rifle would only shoot about 20% of the steel case rounds the first time through. It shot brass about 60% first time through. The lower came with a “BLITZKRIEG” trigger group. The hammer spring was extremely small and couldn’t be replaced with a fully grown spring. I installed a CMC 3.5lb trigger group and my rifle now eats EVERYTHING…steel as well as brass, without fail!
With Hardened Arms, expect huge tolerances. Usually the anti-walk junk screws aren't needed. In this case, use them. Three and a half pound pull.
I put two of these in both ar pistols. Let me tell you
This is exactly what I’d expect a Cabela’s shoppers AR to look like😂😂 eBay special scope that’s on two different mounts and the pointless laser sticking out looking stupid as hell
what happened to the maglock ?
Thank you Simple’s right to the point help me a lot on my drop in trigger. Listen to him people don’t take the hand grip completely off way easier his way
Orgasmic. Thanks for doing the video.
That trigger guard is all I see 😵💫
Just put this trigger in my Ar thanks for this video were did you get the mag release button?
Appreciate the video!
Is there a reason you re-inserted the safety before adding the pins/screws to the trigger assembly?
Thanks for the vid, I am sold!
Great video & review I can’t wait to install my CMC Trigger it’s currently shipping to me at the moment. Hope you and yours are staying safe and healthy 🍻💯🙌🏽🔥👍🏽👍🏽 take care.
Such a nice looking trigger! Love how happy you are with your new trigger only some people would understand haha
Great video. Good, simple explanations!
What mag release is that?
Hey if your busy your busy lol
3.5 pound pull
Your mag release is an AR-Maglock filed down.
The screw heads are Torx
Thank you for posting this video as I’ve been really considering adding one of these in my M4
Do not use red Loctite as it is semi-permanent.