Presenting the Palmetto State Armory AR15 Build that included 16″ Chromoly Nitride coated M4 Carbine length barrel with 1/7″ twist, Gray colored Magpul MOE hardware and PSA Enhanced Polished Trigger (EPT), build onto an Anderson No-Logo Lower that cost about $42 dollars. Also comes with a Magpul MBUS rear plastic sight.
The weight of the complete build with a 30-round Gen 2 PMAG is 6lb 7oz.
0:00 Introduction
2:20 Unboxing PSA Kit
4:30 Assembled Upper Receiver w/BCG & CH
6:45 Carbine Length vs Mid Length gas tube of Aero Precision
7:34 Lower Receiver Kit Unboxing
14:50 Trigger Guard Install
18:17 Oooops stripped trigger guard screw!
19:21 Bolt Catch Install
23:21 Front Takedown Pin Install
25:25 Magazine Release Install
27:24 Trigger Group Install
32:56 Pin notch direction
33:35 IMPORTANT! Hammer spring position note
34:44 Safety Install
37:09 Grip Install (including safety detent spring)
39:20 Rear takedown pin + buffer tube install
46:28 Putting upper receiver to lower receiver
48:28 Stock Install
49:19 Conclusion/Takeaway
#AR15 #ar15build
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
channellock pliers work great on roll pins.