Installation and full review of the STNGR HWK 15in M-Lok Free Float Handguard for the AR platform. Excellent quality lightweight handguard at a budget price and loaded with features…links below…
Deals, Product Links, and More ►
PATREON – Help Support the Channel ►
Buy Aeroshell Grease ►
Buy Upper Vise Block ►
Buy Tekton Torque Wrench ►
Buy Magpul RLS Two Point Sling ►
Buy STNGR Indestructible Range Sunglasses ►
Buy Sig Sauer Romeo5 Red Dot Sight ►
Buy Primary Arms 50k Hour Red Dot Sight ►
Buy AT3 Tactical RD-50 Micro Red Dot Sight ►
Buy TEKTON Hex Key Set ►
Buy Bulk Break-Free CLP Oil ►
Buy Universal Firearm Cleaning Kit ►
Buy Tipton Cleaning Picks ►
Buy Champion Steel Target Base ►
Buy Champion Steel Target Topper ►
Buy AR500 Steel Silhouette ►
Favorite Products on Amazon ►
Subscribe ►
Instagram ►
Facebook ►
Twitter ►
**Disclaimer** Some of the links above are sponsored and a portion of the sales goes to supporting the channel.
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
GunMagWarehouse has the Lancer Red Magazines for the best price ► http://bit.ly/2Zdx9vI
Geeze this is quite the process. I don’t have any of those tools except for screw driver.
Cheers bro, this was thorough and really helped me get my HWK 15 on my rifle. Thanks man.
Hey….how did you put your fore grip on STNGR??
What are the tools ONLY needed to install this handguard?
Good video, I would suggest having crowsfoot 90 degrees from the wrench it will give more accurate reading do to pressure placement
So no alignment of the gas tube or even the guard then? As opposed to having to get the torque adjusted within alignment notches for both gas tube and guard. Interesting. One note, is that really a 90* on your torque wrench? Looked like full in-line orientation to me.
Did you use the same gas block that was originally on your gun or was it a low profile gas block? I have an Anderson am15 but dont know if my gas block will work on it or if I need a low profile gas block instead
Do you need the low profile gas block in order to install the handguard?
Do m lok rails stay attached to this handguard good?
What length barrel is that… 16”?
Will this handguard work for the ruger ar 556?
EXCELLENT VIDEO! I’m sold. Thank you!
Is it necessary to take off the flash hider if your ar already has a low profile gas block on it ?
Do you prefer angles foregrip or vertical foregrip on your AR15?
Mine came in today! Super excited my m and p comes in Friday
what size torque wrench drive does the crow's foot accept?
???????????????
0.5inc?? same to 12,7mm same
what size torque wrench drive does the crow's foot accept?
If I cut down my A2 front sight, will it fit comfortably inside this rail?
Do u have to take off the whole upper just to change the hand guard?????
Thank you great guide
Too bad you don't know what a 90° angle is….
I just got mine. And thanks to you now I have the torque value to install it. My rifle is a Bravo Company. Thank you!
Just ordered the same one from stngr. Can't wait to install!
Did you red loctite the gas block bolts when you cranked them down?