Lot’s of improvements over the older versions. Including reinforced front take down pins. Stay tuned for more!
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
Nice design. Have you considered adding a slot in so users can re-enforce the buffer spring retention pin? 9/10 times I see these fail before anything else on most printed ar receivers.
Just ordered the reinforcement kit can’t wait to try it out when it arrives
Hes back!!! Looks great man! Just curious what are you torqing that that castle nut too? I think it's suppose to be at 40 to 60 lbs if I remember correctly?
Website?
Can you do a glock mag AR9 please
Can you do one with a u bolt? I hate hose clamps because thin metal sucks.
Torture test?
Nice design. I really like that you're reducing post-processing with the custom supports. Design for manufacture 👌
This is amazing!
Which 3d printer should I get? I want the best and would like to buy it right the first time.
Flashforge Creator Pro 2???
Original Prusa i3 MK3S+ kit??
creality3d-ender-6-3d-printer??
Ender 3 Pro???
Or anything else you think I didn’t list.
Thanks!!
Check thingiverse for "5 degree cant AR grip." Might be a good start for that grip
Could use a band style clamp instead of hose clamp.
A truly elegant design. Great work!
You going to jail get rid of them and all the software
Do a 20 and 30 round magazine. That's the next step. Become self sufficient.
This is utterly beautiful
If you used a upper without a forward assist you could mirror the reinforcement from the left side.
please make a ubolt version, the hose clamp lower are not compatible with magpul grips. the front take down pin design is the best we've seen yet though
I believe ghost guns are now banned! Watch for the ATF at your door?
Can't wait for the file drop!
great work! much appreaciated
Yo, why is your website down?
Awesome. One day I will get a printer and do a .22 AR build (: