Installing the Magpul CTR stock on the Spikes Tactical lower, Mil Spec. This AR-15 will be chambered in 300 Blackout.
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
ATTENTION ALL MAGPUL CTR & MOE OWNERS WHO ARE LOOKING TO PIN YOUR STOCK:
Zero cost, drill one hole, its that simple. Just remove the roll pin holding the plunger assembly. Remove spring and cross bar. Re-insert plunger into stock attached to buffer tube and position length to where you want to pin. Rotate plunger 90 degrees, to where a pre-drilled hole at bottom of plunger lines up to any side of stocks roll pin hole, re-insert pin and firmly tap the roll pin to hold plunger in place. Flip the stock over and use a 3/32 drill bit inserted into the roll pin hole to drill hole into the other side of the plunger. Once hole is drilled, remove roll pin from other side and tap roll pin into the hole just drilled to pin plunger in place. You're done.
Worst case scenario buy a new roll pin (3/32 x 3/4) @ $.50 – $.60.
I put the Magpul MOE+ grip on my AR yesterday and tomorrow I'm getting the CTR stock! Too excited! Also, thank you for showing me the easy way to get the stock on the buffer tube, hahaha. That was awesome.
Lol….there's slop because you failed to engage the secondary lock. Why did you buy the ctr? Possibly the moe stock is more your style?