Shooting my BCM AR-15 at Wolverine (my local gun range). Still fine tuning the Eotech, a little low and to the left in this video.
I built the rifle after a lot of research over the last year.
It is a mid-length gas system and is 100% mil-spec and every part on the rifle is 100% American made.
-BCM Upper Receiver, 16″ M.P./H.P. Hammer Forged Barrel
-BCM Bolt Carrier Group
-BCM Lower Receiver
-BCM “Gunfighter Mod. 4″ charging handle
-Daniel Defense 9.0” Lite free floating hand guard
-Troy Ind. flip up rear iron sight
–Magpul CTR stock
–Magpul MOE+ grip
–Magpul B.A.D. lever
–Magpul A.S.A.P. rear sling attachment
–Magpul 2xAA battery grip compartment
–Magpul 30 rnd PMAGs w/level indicators
–Magpul PMAG Ranger Plates
–Magpul MS3 Sling
-Daniel Defense Rail Mounted Sling Swivel
-LaserMax UniMax Green strobing laser
-Battlecomp Mossie Midnight FSP picatinny mount
-Spikes Tactical Havoc 37mm
-Accu-Wedge
Lasermax Uni-Max G. I sold it because it went through batteries like crazy and was strobe only. Eotech 552 sight. Gun is still being torture tested…its at 1,200 rounds never cleaned once with 0 malfunctions.
@JuanSouth2010 mind battlecomp 2.0
@JuanSouth2010 never
What muzzle brake do you have?
The barrel length is the legal requirement at 16 inches. The recoil is due to the stock A2 birdcage style flash hider which has since been switched to a battle comp 2.0. Check my latest video upload to see the dramatic improvement, especially with rapid firing.
With those short barrels the recoil must be tough.