I guess you could call this part 2 of my building an AR15 series. I am in the process of building another AR15 so I decided to break out the camera and film the upper receiver assembly. Its a little intimidating if you dont know what youre doing but actually is very simple. Just takes patience.
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
I use a push pin punch for the bulk of the work. I put masking tape around the pin hole for any punch jumps. Another trick is to use a couple of wide rubber bands stretched over the plunger up to the barrel threads to keep it depressed.
If you don'y use the C clip, what will prevent it from falling out towards the rear of the receiver?
Great title info-Just Forward Assist &Dust Cover. Keeps us from spending a bunch of time. Thx
Great video! It was a big help to me on my first build of a stripped upper. Thanks!
Complete and fairly well explained, but not concise. In conversation I have no room to talk, pardon the pun, but brevity as long as it is not in the loss of relevant information is best for imparting concepts and training. Nice work, regardless.
Damn I have that set…it bends too much