Home EOTech eotech torture test.mov

eotech torture test.mov

1180
12

I tested the EOTech XPS 2-0 for durability. It still works and holds a zero after this and other “tests” I did. The EOTech is sitting on top of an ADM EOTech mount, BCM upper and BCG, and Armalite M-15 lower. The Jeep was going 20 MPH when I threw the rifle out the back, and about 10 MPH when my friend ran it over. The 12 gauge loads were 7 1/2 2.5″ winchester target loads shot out of a Remington 870 18.5″ barrel.

Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.

12 COMMENTS

  1. did you just run over your rifle with the car? im surprised the rifle is in one piece much less your optic. even the aimpoint guys aren't that extreme, they just toss the aimpoint across the ground a few times. your are 100% nuts!!!!!!

Leave a Reply