One way to pin an AR stock if you live in a restricted state
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
One way to pin an AR stock if you live in a restricted state
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
This has to be the worst how to video I ever saw guy just goes on talking and talking and doesn’t show how to actually do it
Sorry but why do some states not allow "telescopic stocks"? Yes I tried googling..but FAILED.
You do know they have the restricted version right? Nice video anyway! 😁
Parallax tactical PXT MFT fixed stock kit stock lock on amazon 9.95
MFT now sells a compliant one that has a roll pin and hole drilled in the pin for you.
Great idea.
couldnt you just remove the lever and achieve the same result?
A wood wedge under the release, if accessable. Small drop of super glue. Move out of state just chip it out
By any chance have you removed the pin to check the function of the stock after being drilled through?
Can you just drill through the plunger right above the plastic to make it not move also?
can I leave it at any position pinned or does it have to be at position 1?
fools.. wake up. u really think u can satisfie those politicians who are hell bent on taking away your rights? by going around, making changes, like a circus poodle jumping through hoops…
ATTENTION ALL MAGPUL CTR & MOE OWNERS WHO ARE LOOKING TO PIN YOUR STOCK:
Zero cost, drill one hole, that simple. Just remove the roll pin holding the plunger assembly. Remove spring and cross bar. Re-insert plunger into stock attached to buffer tube and position length to where you want to pin. Rotate plunger 90 degrees, to where pre-drilled hole at bottom of plunger lines up to any side of stocks roll pin hole, firmly re-insert the roll pin to hold plunger in place. Flip the stock over and use 3/32 drill bit inserted into the roll pin hole to drill hole into the other side of the plunger. Once hole is drilled, remove roll pin from other side and tap roll pin into the hole just drilled to pin the plunger in place. Done.
Worst case scenario buy new roll pin (3/32 x 3/4) $.50 – $.60.
Thanks, good job.
I'm gonna put a dildo on my ar-15 like a bayonet. I wonder if California will ban that too
smart video
To be clear, you are drilling not just through the plastic where plunger is located, but through the metal plunger as well, correct?
What pistol grip is that? I like it
In California, thank you for the DIY. Getting this stock this week. As the new laws have been passed over here. I have to do this if I don't want to register my rifle as an, "Assault weapon." Plus get a kydex wrap for my grip and no more flash hider. Has to be a compensator. At least I'll be able to drop the bullet button.
Great video! I have a MFT Minimalist stock myself and I'm looking to pin it (but I wasn't sure where'd be the best place to drill the hole). Thanks for the DIY!
I'm in Mass also and have the same stock and I was wondering how I was going to pin it. Nice and clean. Thanks!!!
In New York , if you pin the magazine you don't have to have a pinned stock. I notice you have a pistol grip on your gun which you can't have unless you're mag is non removable. So I'm confused as to why you are pinning your stock.
sheeple