Home EOTech Using a Laser Bore Sight to Quickly Align Your EOTECH Holographic Sight...

Using a Laser Bore Sight to Quickly Align Your EOTECH Holographic Sight – HOW TO

1586
13

Using a Laser Bore Sight to Quickly align your EOTECH Holographic Sight – Check out the easy way to get your EOTECH holographic sight on point and zeroed correctly. I am no expert, but this system works for me and if you are an average joe/jane looking for easy instructions, this is for you.

Buy your EOTECH sights here:

BUY your Laser Bore Sights here:

Shop online at TacDaddy.com:

Subscribe :

Like the TacDaddy on Facebook:

Follow the TacDaddy on Twitter:

TacDaddy on Google+:

GUNLINK is where we talk –

TacDaddy LIVE – a new show about life, liberty, and the pursuit of fun and happiness……
Tune in THURSDAYS at 9pm Eastern standard time in the USA and participate via chat on google+ hangouts. Thanks for watching!

Vigilant Spectre Operations

Glock Brothers

All content is original in nature and owned by this channel. Music may include “Royalty Free Music” purchased on iTunes and downloaded to iTunes and iMovie for use legally and with consent from producer and Apple Inc.

Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.

13 COMMENTS

  1. It will be faster if you put the dot of the eotech roughly 2'' higher than your laser bore sight at that range, it should put you right on that diamond quickly, then just refine it from there using your sand bag for a more accurate zero.

Leave a Reply