The Wheeler Engineering Professional Scope Mounting Kit was engineered by Battenfeld Technologies, Inc. The kit includes a F.A.T. Wrench, 10 bits, 1/2″ socket, the Wheeler Level-Level-Level, Flex driver, lapping bars, alignment bars, lapping bar handle, lapping compounds, thread locker, carrying case and instructional video.
Note to readers: Please click the share buttons above or below. Forward this article to your email lists. Crosspost on your blog site, social media, internet forums. etc.
– Battenfeld Technologies:
An exceptionally poor instruction video for Wheeler Engineering's Professional Scope Mounting Kit.
"Fails" in almost all regards if this is meant to be instructional . Does not go over how to use each and every piece/part of the kit. Also fails from the standpoint of correct terminology– states 'pounds per square inch' of torque, while that should be 'inch pounds' as the actual install torque value. Lord help the poor installer should he attempt to tighten scope ring screws to the value you state…
In all, a very dissatisfying video. You should be ashamed!!! That's why you're given a "Fat Minus!"
That's in "inch pounds" Lol
how do you know how much torque pounds to set for your scope rings? you said from 10 pounds to 65 pounds per square inch. how do we know what to set it at?!
i have a ruger precision rifle 308 caliber and im mounting a leopold 30mm with luepold mark 4 30mm super high rings